I'm not sure if I should not start a new thread - because my situtation is different - but I'm continuing here for now - maybe someone more experienced with forums can advise. This excess water would then evaporate and move throughout the house. Can I just reinforce this wall or do I have to replace it? If they are wet, do not paint the surface. What is a concrete block? What is going on and how do I stop it?
What kind of drill bits do I need for brick or concrete?
The machine screw anchor requires a machine threaded bolt with national coarse threads. Like sheet metal screws, these anchors are also designated by the gauge wire used to produce the screw - 6, 8 and so on. Properly resetting the "Service Engine Soon" light after the Mix the powder with water and apply. Lag shield anchors are available in short and long lengths. I have a water leak between my meter and house. You can patch any obvious holes or cracks with hydraulic cement.
Santa Clara, CA www. He holds a bachelor's degree from the University of Arkansas. Simply painting the concrete floor and foundation walls, if in good condition, may result in a pleasant environment without major risk. Learn the best HVAC solutions for high-performance homes. Each type of wall should be addressed a bit differently.
There's other portions of the basement wall that I've painted as well but there's no moisture problems there. In the event that the coating fails, your remedy is limited to either replacement of the product purchased or refund of the purchase price. Old paint in poor condition should be removed by wire-brushing, sandblasting or other suitable methods. Is the damage to the wall or the floor? The entry of moist air is managed by sealing gaps against air intrusion. The soil type around the house I'm pretty sure is pure sand even 20 ft. You are merely talking of allowing drainage once the water gets into the walls.